BIOSTAR P4M800PRO-M7 MANUAL PDF

The CPU will fit only in the correct orientation. Step Step Step 3: Hold the CPU down firmly, and then lower the lever to locked position to complete the installation. The fan cable and connector may be different according to the fan manufacturer. Connect the fan cable to the connector while matching the black wire to pin 1.

Author:Arashikasa Guk
Country:Peru
Language:English (Spanish)
Genre:Software
Published (Last):13 September 2013
Pages:78
PDF File Size:17.27 Mb
ePub File Size:17.93 Mb
ISBN:452-9-39597-905-7
Downloads:32882
Price:Free* [*Free Regsitration Required]
Uploader:Gardakazahn



The Setup program allows users to modify the basic system configuration. This special information is then stored in battery-backed RAM so that it retains the Setup information when the power is turned off. The Main Menu allows you to select from several setup functions. Power Management Setup This submenu allows you to configure the power management features. PC Health Status This submenu allows you to monitor the hardware of your system. Each category includes no, one or more than one setup items.

Item Options Description Date mm : dd : yy Set the system date. The Choices: Disabled default , Enabled. Figure 3. This will depend on which Hard Disk is installed. B oot Other Device When enabled, BIOS will try to load the operating system fro m other device when it failed to load from the three devices above. State after power on.

The Choices: On default Numpad is number keys. Numpad is arrow keys. Typematic Rate Setting When a key is held down, the keystroke will repeat at a rate determined by the keyboard controller. This chipset manage bus speeds and access to system me mory resources, such as DRAM. It also coordinates communications with the P CI bus. The default settings that came with your system have been optimized and therefore should not be changed unless you are suspicious that the settings have been changed incorrectly.

The submenu will appear, providing you the following options: Figure 4. The Choices: 4T default. Active to Precharge Tras This item allows you to specify the minimum bank active time.

The Choices: Default default , Slowest, Optimize. When this area is reserved it cannot be cached. Integrated Peripherals Modes 0 to 4 will increase performance progressively. You will need to disable this feature if you add a higher performance controller. If install and FDC or the system has no floppy drive, select Disabled in this field.

The Choices: Enabled default , Disabled. HDD Power Down. Suspend Mode. There are four options of P ower Management, three of which have fixed mode settings Min. Blank Screen This option only writes blanks to the video buffer. If AC power is lost when system is not live, system will remain powered off.

Resume Time hh:mm:ss You can choose the hour, minute and second the system will boot up. This section covers some very technical items and it is strongly recommended that only experienced users should make any changes to the default settings.

Every peripheral device has a node, which is called ESCD. This node records which resources are assigned to it. Some graphic controllers which are not VGA compatible take the output from a VGA controller and map it to their display as a way to provide boot information and VGA compatibility. The Choices: Smart, Always On default. The Choices: 8X default. The Choices: Mhz default ,.

DR.BOB AND THE GOOD OLD TIMERS PDF

Biostar P4M800-M7 A User Manual

Page Components: P4mm7 A rev 7. Back panel connectors rear side. This completes the installation. This motherboard is equipped with 3 standard PCI slots.

JIM MIOTKE PDF

BIOSTAR P4M800 PRO-M7 - BIOS SETUP Bios Setup Manual

.

Related Articles